TRIPPLITE(8) NUT Manual TRIPPLITE(8)

tripplite - Driver for Tripp-Lite SmartPro UPS equipment

This man page only documents the hardware-specific features of the tripplite driver. For information about the core driver, see nutupsdrv(8).

This driver should work on the SmartPro line, including the SMART700 and SMART700SER. It only supports SmartPro models that communicate using the serial port.

This driver supports the following optional settings in the ups.conf(5):

offdelay=num

Time to wait before the UPS is turned off after the kill power command is sent. The default value is 64 (in seconds).

rebootdelay=num

Set the timer before the UPS is cycled after the reboot command is sent. The default value is 64 (in seconds).

startdelay=num

Set the time that the UPS waits before it turns itself back on after a reboot command. The default value is 60 (in seconds).

Battery charge information may not be correct for all UPSes. It is tuned to be correct for a SMART700SER. Other models may not provide correct information. Information from the manufacturer would be helpful.

•Rickard E. (Rik) Faith
•Nicholas Kain

nutupsdrv(8)

tripplitesu(8), tripplite_usb(8), usbhid-ups(8)

The NUT (Network UPS Tools) home page: https://www.networkupstools.org/

01/09/2024 Network UPS Tools 2.8.1