UPSCODE2(8)                       NUT Manual                       UPSCODE2(8)

NAME
       upscode2 - Driver for UPScode II compatible UPS equipment

NOTE
       This man page only documents the hardware-specific features of the
       upscode2 driver. For information about the core driver, see
       nutupsdrv(8).

SUPPORTED HARDWARE
       This driver supports UPS equipment which can be controlled via the
       UPScode II protocol. This is mainly Fiskars, Powerware equipment, but
       also some (probably OEM'ed) products from Compaq.

EXTRA ARGUMENTS
       This driver supports the following optional settings in the
       ups.conf(5):

       manufacturer=value
           Autodetection of this parameter is not possible yet (and it
           probably never will be). Therefore, this user-defined string
           accepts any name. The default is unknown.

       input_timeout=value
           The timeout waiting for a response from the UPS. Some UPS models
           have shown to be rather slow, resulting in frequent messages about
           empty responses from the UPS. If you see this, try increasing this
           value.

       output_pace=value
           Delay between characters sent to the UPS. This was added for
           completeness with the above parameter. It has not shown to be
           needed yet.

       baudrate=value
           The default baudrate is 1200, which is the standard for the UPScode
           II protocol.

       full_update_timer=value
           Number of seconds between collection of normative values.

       use_crlf
           Flag to set if commands towards to UPS need to be terminated with
           CR-LF, and not just CR.

       use_pre_lf
           Flag to set if commands towards to UPS need to be introduced with
           an LF. A Compaq T1500h is known to need this.

COMMANDS
       The driver supports the following commands for those UPSes that support
       them. The available commands are autodetected during initialization, so
       you should check availability with upscmd -l.

       o   test.panel.start - Start UPS self test

       o   test.battery.start - Start battery self test

       o   beeper.enable - Enable UPS beeper

       o   beeper.disable - Disable UPS beeper

       o   shutdown.return - Shut down in 1 second and wait for power to
           return

       o   shutdown.stayoff - Shut down in 1 seconds

       o   shutdown.reboot - Shut down in 1 seconds and reboot after 1 minute

       o   shutdown.reboot.graceful - Shut down in 20 seconds and reboot after
           1 minute

NOTES
       The Powerware UPS models that this driver has been tested against until
       now have not returned a value for battery.charge. Therefore, the driver
       will guesstimate a value based on the nominal battery min/max and the
       current battery voltage.

AUTHORS
       o   Havard Lygre <hklygre@online.no>

       o   Niels Baggesen <niels@baggesen.net>

SEE ALSO
   The core driver:
       nutupsdrv(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: https://www.networkupstools.org/

Network UPS Tools 2.8.1           04/06/2024                       UPSCODE2(8)