NETHOGS(8)                  System Manager's Manual                 NETHOGS(8)

NAME
       nethogs - Net top tool grouping bandwidth per process

SYNOPSIS
       nethogs [-V] [-h] [-x] [-d seconds] [-v mode] [-c count] [-t] [-p] [-s]
       [-a] [-l] [-f filter] [-C] [-b] [-g period] [-P pid] [device(s)]

DESCRIPTION
       NetHogs is a small 'net top' tool. Instead of breaking the traffic down
       per protocol or per subnet, like most such tools do, it groups
       bandwidth by process - and does not rely on a special kernel module to
       be loaded. So if there's suddenly a lot of network traffic, you can
       fire up NetHogs and immediately see which PID is causing this, and if
       it's some kind of spinning process, kill it.


   Options
       -V     prints version.

       -h     prints available commands usage.

       -x     bughunt mode - implies tracemode.

       -d     delay for update refresh rate in seconds. default is 1.

       -v     view mode (0 = KB/s, 1 = total KB, 2 = total B, 3 = total MB, 4
              = MB/s, 5 = GB/s). default is 0.

       -c     number of updates. default is 0 (unlimited).

       -t     tracemode.

       -p     sniff in promiscuous mode (not recommended).

       -s     sort output by sent column.

       -l     display command line.

       -a     monitor all devices, even loopback/stopped ones.

       -C     capture TCP and UDP.

       -b     Display the program basename.

       -g     garbage collection period in number of refresh. default is 50.

       -P     Show only processes with the specified pid(s).

       -f     EXPERIMENTAL: specify string pcap filter (like tcpdump). This
              may be removed or changed in a future version.

       device(s) to monitor. default is all interfaces up and running
       excluding loopback


INTERACTIVE CONTROL
       q      quit

       s      sort by SENT traffic

       r      sort by RECEIVED traffic

       l      display command line

       b      display the program basename

       m      switch between total (KB, B, MB) and throughput (KB/s, MB/s,
              GB/s) mode


RUNNING WITHOUT ROOT
       In order to be run by an unprivileged user, nethogs needs the
       cap_net_admin and cap_net_raw capabilities. These can be set on the
       executable by using the setcap(8) command, as follows:

           sudo setcap "cap_net_admin,cap_net_raw+pe" /usr/local/sbin/nethogs

Notes
       1. When using the -P <pid> option, in a case where a process exited
       (normally or abruptly), Nethogs does not track that it exited. So, the
       operating system might create a new process (for another program) with
       the same pid. In this case, this new process will be shown by Nethogs.

SEE ALSO
       netstat(8) tcpdump(1) pcap(3)

AUTHOR
       Written by Arnout Engelen <arnouten@bzzt.net>.

                               14 February 2004                     NETHOGS(8)