ZMQ_TIPC(7) 0MQ Manual ZMQ_TIPC(7)

zmq_tipc - 0MQ unicast transport using TIPC

TIPC is a cluster IPC protocol with a location transparent addressing scheme.

A 0MQ endpoint is a string consisting of a transport:// followed by an address. The transport specifies the underlying protocol to use. The address specifies the transport-specific address to connect to.

For the TIPC transport, the transport is tipc, and the meaning of the address part is defined below.

When assigning a port name to a socket using zmq_bind() with the tipc transport, the endpoint is defined in the form: {type, lower, upper}

•Type is the numerical (u32) ID of your service.
•Lower and Upper specify a range for your service.

Publishing the same service with overlapping lower/upper ID’s will cause connection requests to be distributed over these in a round-robin manner.

When connecting a socket to a peer address using zmq_connect() with the tipc transport, the endpoint shall be interpreted as a service ID, followed by a comma and the instance ID.

The instance ID must be within the lower/upper range of a published port name for the endpoint to be valid.

Assigning a local address to a socket.

//  Publish TIPC service ID 5555
rc = zmq_bind(socket, "tipc://{5555,0,0}");
assert (rc == 0);
//  Publish TIPC service ID 5555 with a service range of 0-100
rc = zmq_bind(socket, "tipc://{5555,0,100}");
assert (rc == 0);

Connecting a socket.

//  Connect to service 5555 instance id 50
rc = zmq_connect(socket, "tipc://{5555,50}");
assert (rc == 0);

zmq_bind(3) zmq_connect(3) zmq_tcp(7) zmq_pgm(7) zmq_ipc(7) zmq_inproc(7) zmq_vmci(7) zmq(7)

This page was written by the 0MQ community. To make a change please read the 0MQ Contribution Policy at http://www.zeromq.org/docs:contributing.

10/23/2023 0MQ 4.3.5