HORST.CONF(5) File Formats Manual HORST.CONF(5)

horst.conf - configuration file for horst(8)

/etc/horst.conf

The file /etc/horst.conf is the default configuration file. The configuration file consists of zero or more lines. Each line must be either EMPTY, COMMENT or OPTION and must end with a new line character ('\n', ASCII 0xa).

EMPTY lines must have zero or more spaces (' ', ASCII 0x20).

COMMENT lines must begin with a hash sign ('#', ASCII 0x23).

OPTION lines must be in the following form:

option[=value]

Options and their acceptable values are described below in section OPTIONS.

Lines not matching the format described above will cause horst to exit with non-zero status.

Set the initial channel number to which horst tunes the radio at startup.
Set the time horst scans each channel when channel_scan=1 is defined.
Make horst change/scan channels automatically in ascending numeric order.
Set the number of rounds horst scans the channel range when channel_scan=1 is defined. When N is reached, horst exits with zero status. If N is a negative number, horst scans the channel range infinitely.
Set the highest channel horst will change to when channel_scan=1 is defined. When CHANNEL_NUMBER is reached, the next channel will be 1.
Run horst in client mode and connect to a server running in SERVER_ADDRESS.
Accept control commands on a named pipe.
Set the refresh interval of the user interface display. This option can be used to reduce CPU load by using longer intervals.
Set the initial display view.
Ignore all packets except packets belonging to BSSID.
Ignore all packets except packets originating from MAC_ADDRESS.
Ignore all packets/nodes except packets/nodes of mode MODE.
Ignore all packets except packets of type PACKET_TYPE.
Set the wireless interface which horst uses to monitor the radio spectrum. If interface INTERFACE_NAME is not already in monitor mode at startup, horst first tries to put the interface in monitor mode and if it fails, a temporary virtual monitor interface is added and used instead. The name of the temporary virtual monitor interface is in the form horst[0-9]+. The virtual interface created by horst is deleted at exit.
Always add virtual monitor interface. Don't try to set existing interface to monitor mode.
The file containing a mapping from MAC addresses to host names. The file can either be a dhcp.leases file from dnsmasq or contain mappings in the form "MAC<space>name" (e.g.: "00:01:02:03:04:05 test") line by line.
Set the time after nodes will be removed if no frames have been received from them.
Write information about each received packet to FILEPATH.
Set the port horst listens to when run in server mode or the port which horst connects to when run in client mode.

Make horst less verbose and suppress the user interface.
Set the size of the receive buffer. This option can be used to tune memory consumption and reduce packet loss under high load.

Run horst in server mode.

horst(8)

September 29, 2016