DNSSEC-REVOKE(1) BIND 9 DNSSEC-REVOKE(1)

dnssec-revoke - set the REVOKED bit on a DNSSEC key

dnssec-revoke [-hr] [-v level] [-V] [-K directory] [-E engine] [-f] [-R] {keyfile}

dnssec-revoke reads a DNSSEC key file, sets the REVOKED bit on the key as defined in RFC 5011, and creates a new pair of key files containing the now-revoked key.

This option emits a usage message and exits.
This option sets the directory in which the key files are to reside.
This option indicates to remove the original keyset files after writing the new keyset files.
This option sets the debugging level.
This option prints version information.
This option specifies the cryptographic hardware to use, when applicable.

When BIND 9 is built with OpenSSL, this needs to be set to the OpenSSL engine identifier that drives the cryptographic accelerator or hardware service module (usually pkcs11).

This option indicates a forced overwrite and causes dnssec-revoke to write the new key pair, even if a file already exists matching the algorithm and key ID of the revoked key.
This option prints the key tag of the key with the REVOKE bit set, but does not revoke the key.

dnssec-keygen(8), BIND 9 Administrator Reference Manual, RFC 5011.

Internet Systems Consortium

2024, Internet Systems Consortium

2024-09-18 9.20.2