|git-annex-fromkey(1)||General Commands Manual||git-annex-fromkey(1)|
Multiple pairs of file and key can be given in a single command line.
If no key and file pair are specified on the command line, batch input is used, the same as if the --batch option were specified.
Normally the key is a git-annex formatted key. However, to make it easier to use this to add urls, if the key cannot be parsed as a key, and is a valid url, an URL key is constructed from the url. Note that this does not register the url as a location of the key; use git-annex-registerurl(1) to do that.
- Allow making a file link to a key whose content is not in the local repository. The key may not be known to git-annex at all.
- In batch input mode, lines are read from stdin, and each line should contain a key and filename, separated by a single space.
- When in batch mode, the input is delimited by nulls instead of the usual newlines.
- (Note that for this to be used, you have to explicitly enable batch mode with --batch)
- Enable JSON output. This is intended to be parsed by programs that use git-annex. Each line of output is a JSON object.